 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Telefon: +49 (0)6135 931069 Telefax: +49 (0)6135 931070 www.peak-electronics.de info@peak-electronics.de PD10NG-XXXXZ2:1H30 3KV ISOLATED 2W REGULATED DUAL OUTPUT SIP8 Electrical Specifications (Typical at + 25 , nominal input voltage, rated output current unless otherwise specified) Input Specifions Voltage range Filter 4.5-9, 9-18, 18-36 and 36-72 VDC Wide lnput Capacitor type 3000 VDC 1 G 72PF +/-2 %, typ. 100 mV p-p, max. Continuous, auto restart +/-0.2 % typ. +/-0.5 % typ. load = 10 ~ 100% +/-0.02 % / Continuous, auto restart 75 KHz, typ. - 40 to + 80 - 55 to + 125 Up to 90 %, non condensing Free air convection 21.80 x 9.20 x 11.10 mm Non conductive black plastic lsolation Specifications Rated voltage Resistance Capacitance Output Specifications Voltage accuracy Ripple and noise (at 20 MHz BW) Short circuit protection Line voltage regulation Load voltage regulation Temperature coefficient General Specifications Efficiency Switching frequency Environmental Specifications Operating temperature (ambient) Storage temperature Humidity Cooling Physical Characteristics Dimensions SIP Case material Samples of Partnumbers PART NO. INPUT VOLTAGE (VDC) INPUT CURRENT NO LOAD (mA) INPUT CURRENT FULL LOAD (mA) OUTPUT VOLTAGE (VDC) OUTPUT CURRENT (max.mA) EFFICIENCY FULL LOAD (% TYP.) PD10NG-053R3Z2:1H30 PD10NG-0505Z2:1H30 PD10NG-0509Z2:1H30 PD10NG-0512Z2:1H30 PD10NG-0515Z2:1H30 PD10NG-0524Z2:1H30 PD10NG-123R3Z2:1H30 PD10NG-1205Z2:1H30 PD10NG-1209Z2:1H30 PD10NG-1212Z2:1H30 PD10NG-1215Z2:1H30 PD10NG-1224Z2:1H30 PD10NG-243R3Z2:1H30 PD10NG-2405Z2:1H30 PD10NG-2409Z2:1H30 PD10NG-2412Z2:1H30 PD10NG-2415Z2:1H30 PD10NG-2424Z2:1H30 PD10NG-483R3Z2:1H30 PD10NG-4805Z2:1H30 PD10NG-4809Z2:1H30 PD10NG-4812Z2:1H30 PD10NG-4815Z2:1H30 PD10NG-4824Z2:1H30 4.5 - 9 4.5 - 9 4.5 - 9 4.5 - 9 4.5 - 9 4.5 - 9 9 - 18 9 - 18 9 - 18 9 - 18 9 - 18 9 - 18 18 - 36 18 - 36 18 - 36 18 - 36 18 - 36 18 - 36 36 - 72 36 - 72 36 - 72 36 - 72 36 - 72 36 - 72 41 37 37 35 35 35 24 23 22 22 22 22 12 12 12 12 12 11 8 6 7 6 6 6 487 473 467 442 442 442 237 227 213 213 213 213 117 109 108 109 107 106 58 54 53 52 52 52 +/- 3.3 +/- 5 +/- 9 +/- 12 +/- 15 +/- 24 +/- 3.3 +/- 5 +/- 9 +/- 12 +/- 15 +/- 24 +/- 3.3 +/- 5 +/- 9 +/- 12 +/- 15 +/- 24 +/- 3.3 +/- 5 +/- 9 +/- 12 +/- 15 +/- 24 303 200 111 83 67 42 303 200 111 83 67 42 303 200 111 83 67 42 303 200 111 83 67 42 68 70 71 75 75 75 70 73 76 78 78 78 71 76 77 76 77 78 72 77 78 80 80 80 PD10NG-XXXXZ2:1H30 3KV ISOLATED 2W REGULATED DUAL OUTPUT SIP8 Dimensions PEAK Modelcode 21,8 9,2 1 23 5 678 11,10 0.50 0.05 3.10 typ. 0.50 0.05 2.54 typ. 0.25 0.05 3.20 typ. 2.0 0.50 Recommended footprint details 2,54 XX.X 0.5m/m XX.XX 0.25m/m Unit : mm 1.00.15 /0 2,54 Derating Graph and Pinning Output Temperature Derating Graph Ambient Temperature C Pin # 1 2 Connection Dual - + V V Input Input Ctrl Omitted NE + - V V Output Output Com 2.00W 3 4 5 Safe Operating Area 6 7 8 40 0 40 80 100 Control input can be left open (3) No external connection allowed (5) PD10NG-XXXXZ2:1H30 3KV ISOLATED 2W REGULATED DUAL OUTPUT SIP8 External capacitance: These converters will work with without external capacitors but they are necessary in order to guarantee the full line load range. All parts have been tested using the following recommended values. + Vout + Vin Cin - Vin Pin 3 (CTRL) Control pin (ON/OFF) Output starts at low or open and stops when high. Voltage applied via a limiting resistor and switching diode. The converter is in a low power mode during the high level phase. Connection example Cout 1 Com Cout 2 1K 1N4148 CONVERTER Converter - Vout Cin 10uF/100V, low ESR. Cout 1/ Cout 2 100uF/25V, low ESR. MCU Vcc-5V PIN 3 Pin 5 (NE) This pin is used internally and must have have no external connection. Application Notes Pin 3: The outside control connection. This pin provides the converter output ON/OFF, and the control common is referred to negative input. Pin 5: This pin belongs to the secondary side. It just avoids someone to reverses the primary and secondary. Specification can be changed without notice. Copyright PEAK electronics GmbH REV: 1 / 03.2003 |
Price & Availability of PD10NG-483R3Z21H30
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |